Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 98

2 Inheriting Optional Physical MAC address. For details, see
.
on page
3 The MAC address that is set MAC categorization is used. For details, see
.
WWN and MAC addresses in basic mode on page
4 Only items in the UEFI settings of the management module Web console are
.
inherited. For details, see
5 When setting the N+M cold standby using Emulex 8 Gb 2-port Fibre Channel
.
mezzanine card or Emulex 16 Gb 2-port Fibre Channel mezzanine card, all setup
menu items of HBA BIOS configuration transfer to the server blade configuration.
6 For these conditions to be inherited, a setting other than FCoE must be specified as
.
the Personality setting of the active server blade and the standby server blade, and
the MultiChannel Support settings must be the same. If Personality is set to FCoE for
the Emulex 10 Gb CNA mezzanine card or the onboard CNA (2 or 4 ports), N+M cold
standby including the card is not supported. If Personality is set to iSCSI for the
onboard CNA (4 ports), N+M cold standby including the card is not supported. For
details about each item, see the following:
¢
¢
¢
7 The following conditions should be required.
.
- Personality configuration of active server blade and standby server blade are NIC
or iSCSI.
- MultiChannel Support settings are the same.
N+M cold standby including the card with FCoE set as Personality is not supported.
For details, see the OneCommand Manager Guide.
8 For details, see
.
2-43.
9 For details, see
.
10 In SMP configuration, setting information of the primary server blade alone is taken
.
over.
11 For the onboard CNA (4 ports), these items are not inherited.
.
Tip:
• When recovering the N+M cold standby, the active server blade return to
the status as before switching the N+M cold standby. The inherited
information is returned to the active server blade from the standby server
blade. The standby server blade still have the inherited information,
therefore, the standby server blade do not return the status as before
switching the N+M cold standby.
(For WWN and MAC address, the standby partition returns the status as
before switching the N+M cold standby.)
• When Emulex CNA is used with iSCSI for Personality, an IP address and
SubnetMask for iSCSI Initiator are cleared to 0, zero, in the faulty active
server blade at the failover time and restored standby server blade at the
restore time.
2-74
Hitachi Compute Blade 500 Series Management Module Setup Guide
Division
2-54.
Hitachi Compute Blade Emulex Adapter User's Guide for Driver
Hitachi Compute Blade Emulex Adapter User's Guide for Hardware
Hitachi Compute Blade Emulex Adapter User's Guide for Utility
Server blade operation setting when power failure recovery on page
N+M cold standby configuration procedure on page
Functional detail
Item
2-57.
Server blade (UEFI settings) on page
Remarks
WWN and MAC addresses
Selecting
2-53.
2-81.