Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 88

ServerNavigator
If the version of any firmware is older than the supported versions, "-----" is
displayed for the host information.
After the OS starts up and the server installation and monitoring tool is
automatically activated, the host information is saved to the server blade.
Even when you change the host name, it is not immediately applied to the
host name displayed on the Web console. To apply the new host name,
restart the OS. Even when you shut down the OS, the host information saved
to the server blade is retained. If you perform the following operations, the
host information displayed on the Web console might be different from the
actual OS information:
• Uninstall the server installation and monitoring tool.
• Uninstall the OS from the server and then reinstall the OS supported by
the server installation and monitoring tool on the server without installing
the server installation and monitoring tool.
• Uninstall the OS from the server and then reinstall the OS not supported
by the server installation and monitoring tool on the server.
If this is the case, delete the host information saved to the server blade.
You can delete the host information from the Web console of the
management module.
Tip: You can delete the host information only when the server blade is
powered off.
Table 2-75 Consoles used to view or delete the host information
Display the host
information.
Delete the host information.
When the server installation and monitoring tool is installed on the active
server blade in the N+M cold standby configuration, the host information is
saved to the standby server blade at the following timing: the N+M failover
occurs and the server installation and monitoring tool starts up on the
standby server blade. Even when the N+M recovery occurs and the active
server blade takes over for the standby server blade, the host information
saved to the standby server blade is retained. You can also delete the host
information saved to the standby server blade by using the host information
deletion functionality.
2-64
Hitachi Compute Blade 500 Series Management Module Setup Guide
- For CB 520H A1/B1: Integrated firmware 01-60 or later
- CB 520A A1: Integrated firmware 02-30 or later
- CB 540A A1/B1: Integrated firmware 03-10 or later
- For other server blades, all versions of integrated firmware are
supported.
X.3.3.6 or later (for ESXi version 4.3.3.3 or later)
Operation
Functional detail
Web console CLI console
Y
Y
LCD touch console
Y --
Y --