Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 283

set remote-access protocol http -a deny
• Setting port 80 to HTTP
set remote-access protocol http -p 80
• Setting limited connection to HTTP
Network address: 192.168.0.100
Subnetmask: 255.255.255.0
set remote-access protocol http -n 192.168.0.100 -s
255.255.255.0
Tip: When setting a protocol except HTTP, change http to telnet, ssh, ftp,
or https. No port number is set to Telnet, SSH, and FTP.
Modifying network settings: examples
The following examples show modification of network settings written in an
import file.
• Management modules
IP address: 192.168.0.1
Subnetmask: 255.255.255.0
Default gateway: 192.168.0.100
DNS server address 1: 158.213.160.152
DNS server address 2: 158.214.50.44
DNS server address 3: 158.215.10.31
set mgmt-module mgmt-lan -i 192.168.0.1 -s 255.255.255.0 -g
192.168.0.100 -d0 158.213.160.152 -d1 158.214.50.44 -d2
158.215.10.31
• Server blade 0
IP address: 192.168.0.10
Subnetmask: 255.255.255.0
Default gateway: 192.168.0.100
set blade mgmt-lan 0 -i 192.168.0.10 -s 255.255.255.0 -g
192.168.0.100
Tip: When changing a server blade to set other than server blade 0,
change the number 0 to 1 - 7.
• Switch module 0
Type of connection: via management module console
¢
set sw-module mgmt-lan 0 -e int
Type of connection: to direct connection from via management LAN
¢
port
IP address: 192.168.0.31
Subnetmask: 255.255.255.0
Default gateway: 192.168.0.100
Hitachi Compute Blade 500 Series Management Module Setup Guide
Functional detail
2-259