Note: When Refresh is clicked after the command shutting down a server
blade is executed, a message showing that an LPAR manager is booting is
displayed until the completion of booting the server blade.
(When Refresh is not clicked, the contents displayed on the screen are not
changed.)
However, when Refresh is clicked immediately after the command shutting
down a server blade is executed, any of the following messages is shown.
•
Message showing that retrieving the data for the state of LPAR manager
failed
•
Message showing that LPAR manager is being shut down
In this case, click Refresh after a while.
Configuring LPAR
Perform the following procedure for configuring LPAR. When logical
partitioning is Enabled and a server blade is turned on, an LPAR can be
created.
1
Click Resources.
.
2-134
Hitachi Compute Blade 500 Series Management Module Setup Guide
Functional detail