Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 308

(Error part: Partition N - LPAR manager; Event: communication error between LPAR
manager and Management Module)
• Perform the update during the period in which the impact to production
operation is small. The delay of the response in the management module
may occur during the update.
• If the management module is switched during version up, the version up
fails. Remove the error factor and then execute the update again.
• When executing update using HCSM, click Refresh after the update and
then check the new version.
When you need to downgrade firmware, consult your reseller or
maintenance personnel.
Update operation flow chart
The following shows the operation flow chart for Management module
firmware, Dictionary, and Equipment parameter.
Make sure to check that the expected new version is shown.
Displaying management
module firmware
Updating management
module firmware
2-284
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-157 Web console operation
Item
Resources > Modules > All Modules > Management
Modules > Management Module x > Condition tab
Resources > Modules > All Modules > Management
Modules > Action button > Update Firmware
Functional detail
Message
Operation