Table of Contents
Advertisement
Figure 38. PCI riser-card assembly installation
Step 4.
Install the cover (see "Replacing the cover" on page 132).
Step 5.
Slide the server into the rack
Step 6.
Reconnect the power cords and cables that you remove
Step 7.
Turn on all attached devices and the server.
Removing an adapter
Use this information to remove an adapter.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 33.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove an adapter, complete the following steps.
Step 1.
Remove the cover (see "Removing the cover" on page 131).
Step 2.
Remove the PCI riser-card assembly (see "Removing the PCI riser-card assembly" on page 136).
Step 3.
Disconnect the cables from the adapter.
Step 4.
Grasp the PCI riser-card assembly at the front grip point and rear edges and lift to remove it
from the server.
Step 5.
Place the PCI riser-card assembly on a flat, static-protective surface.
Step 6.
Carefully grasp the adapter by its top edge or upper corners, and pull the adapter from the PCI
riser-card assembly.
138
Lenovo System x3250 M4 Installation and Service Guide
Riser-card
assembly
Advertisement
Table of Contents
Troubleshooting
