Removing The Operator Information Panel Assembly - Lenovo System x3750 M4 Installation And Service Manual

Step 7. Remove the adapter, if necessary, from the PCI riser-card assembly.
Step 8. Set the adapter and PCI riser-card assembly aside.
Replacing a PCI riser-card assembly
Use this information to replace a PCI riser-card assembly.
To install a PCI riser-card assembly, complete the following steps:
Step 1. Read the safety information and installation guidelines, see "Safety" on page v and "Installation
guidelines" on page 38.
Step 2. Install the adapter in the new PCI riser-card assembly (see "Replacing an adapter" on page 223).
Step 3. Align the PCI riser-card assembly with the PCI slot connector on the system board and align it with
the slot on the chassis; then, lower it into the server and press down firmly until the PCI riser-card
assembly is seated correctly in the connector on the system board.
Step 4. Reconnect any cables that you disconnected earlier to the adapters.
Step 5. Install the cover (see "Replacing the server top cover" on page 216).
Step 6. Slide the server into the rack, if it was in a rack.
Step 7. Reconnect the power cords and any cables that you removed.
Step 8. Turn on the peripheral devices and the server.

Removing the operator information panel assembly

Use this information to remove the operator information panel assembly.
To remove the operator information panel, complete the following steps:
Step 1. Read the safety information and installation guidelines, see "Safety" on page v and "Installation
guidelines" on page 38.
PCI riser-card assembly
(full height, half-length)
Riser-
card
filler
PCI
riser
slot
.
Chapter 6 Removing and replacing components
271