Lenovo System x3750 M4 Installation And Service Manual page 167

Note: If you omit any optional parameter, the default value is used. If one or more default values are used
and the ASU cannot access the IMM by using the LAN over USB access method, the ASU automatically
uses the KCS access method.
asu set SYSTEM_PROD_DATA.SysInfoUUID uuid [–host ipaddress]
[–user userid][–password password]
where:
uuid
is the user-assigned hexadecimal value, up to 16 bytes, that identifies the server.
ipaddress
is the internal LAN/USB IP address of the IMM. The default is 169.254.95.118.
userid
is the IMM account name (1 of 12 accounts). The default is USERID.
password
is the IMM account password (1 of 12 accounts). The default is PASSW0RD (with a zero, not the letter O).
To update the DMI/SMBIOS data, complete the following steps:
Step 1. In the ASU command-line interface, enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoProdName xxxxyyy [–host ipaddress]
[–user userid][–password password]
where:
xxxx
is the 4-digit machine type of the server.
yyy
is the 3-digit model number of the server.
ipaddress
is the internal LAN/USB IP address of the IMM. The default is 169.254.95.118.
userid
is the IMM account name (1 of 12 accounts). The default is USERID.
password
is the IMM account password (1 of 12 accounts). The default is PASSW0RD (with a zero,
not the letter O).
Step 2. Enter the following command:
asu set SYSTEM_PROD_DATA.SysInfoSerialNum zzzzzzz [–host ipaddress]
[–user userid][–password password]
where zzzzzzz is the 7-character serial number of the server.
Step 3. Enter the following command:
asu set SYSTEM_PROD_DATA.SysEncloseAssetTag
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa [–host ipaddress]
[–user userid][–password password]
where aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the 33-character asset tag number of the server.
.
Chapter 3 Configuration information and instructions
153