Lenovo System x3750 M4 Installation And Service Manual page 500

1. If this PCIe device and/or any attached cables were recently installed, moved, serviced or
upgraded, reseat the adapter and any attached cables.
2. Move the adapter to a different system slot, if available.
3. Check the IBM support site for any applicable service bulletin or UEFI or adapter firmware
update that applies to this error. NOTE: It may be necessary to configure slot to Gen1 or to use
special utility software so that adapter firmware can be upgraded. Gen1/Gen2 settings can be
configured via F1 Setup -> System Settings -> Devices and I/O Ports -> PCIe Gen1/Gen2/Gen3
Speed Selection, or the ASU Utility.
4. Replace the adapter.
Related links
– "Removing an adapter" on page 222
– "Replacing an adapter" on page 223
• I.3048005 [I.3048005] UEFI has booted from the backup flash bank. : Booting Backup UEFI Image
Severity
Info
User Response
Complete the following steps:
Return the system to primary bank.
Related links
– "Updating the firmware" on page 131
• I.3808004 [I.3808004] The IMM System Event log (SEL) is full. : IPMI System Event Log is Full
Severity
Info
User Response
Complete the following steps:
1. Use the IMM Web Interface to clear the event log.
2. If IMM communication is unavailable, use the Setup Utility to access the System Event Logs
Menu and choose Clear IMM System Event Log and Restart Server.
• I.3818001 [I.3818001] The firmware image capsule signature for the currently booted flash bank is
invalid. : Current Bank CRTM Capsule Update Signature Invalid
Severity
Info
User Response
Complete the following steps:
1. Reboot the system. Will come up on backup UEFI image. Update the primary UEFI image.
2. If error does not persist, no additional recovery action is required.
486
Lenovo System x3750 M4 Installation and Service Guide