Removing The Operator Information Panel Assembly - Lenovo System x3550 M5 Installation And Service Manual

Four 3.5-inch hot-swap or simple-swap hard disk drive server configuration:
Figure 170. Front video connector assembly installation for four 3.5-inch hot-swap or simple-swap hard
disk drive server configuration
Step 3. Carefully push the media cage back into the chassis (see "Replacing the media cage" on page
237). Remember to reconnect the cables that were removed from the system board.
Step 4. Reinstall the cover (see "Replacing the cover" on page 120).
Step 5. Slide the server into the rack.
Step 6. Reconnect the power cords and any cables that you removed.
Step 7. Turn on the peripheral devices and the server.

Removing the operator information panel assembly

Use this information to remove the operator information panel assembly.
To remove the operator information panel assembly, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the
cover (see "Removing the cover" on page 119).
Step 3. For the eight 2.5-inch hot-swap or simple-swap and ten 2.5-inch hot-swap hard disk drive server
configuration, remove the media cage (see "Removing the media cage" on page 234). For the four
3.5-inch hot-swap or simple-swap hard disk drive server configuration, disconnect the operator
248
Lenovo System x3550 M5 Installation and Service Guide
Video connector
Screws
Media cage