Removing The Operator Information Panel Assembly - Lenovo System x3250 M4 Installation And Service Manual

Step 5. Connect the DVD cable into the connector on the rear of the optical drive cage.
Step 6. Route the DVD signal cable through the fan cage hole on the left of fan 1. The following illustration
shows the cable routing for the DVD signal cable.
Step 7. Secure the cable in the server using the cable tie and cable clip.
Step 8. Reinstall the air baffle if it was removed before (see "Replacing the air baffle" on page 135).
Step 9. Reinstall the cover (see "Replacing the cover" on page 132).
What to do next
1. Slide the server into the rack.
2. Reconnect the power cords and cables that you removed.
3. Turn on all attached devices and the server.

Removing the operator information panel assembly

Use this information to remove the operator information panel assembly.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 33.
170
Lenovo System x3250 M4 Installation and Service Guide
DVD drive SATA
signal cable
DVD drive
power cable