Lenovo System x3750 M4 Installation And Service Manual page 241

Step 3. Install a 2.5-inch hot-swap drive:
a. Make sure that the drive-tray handle is in the open (unlocked) position.
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive-tray assembly into the bay until the drive stops.
d. Rotate the drive-tray handle to the closed (locked) position.
Step 4. Installing a 1.8-inch hot-swap drive:
a. Insert the drive into the drive bay with the label side of the drive facing the right side of the
server.
b. Push the drive tray into the drive bay and rotate the drive tray handle to the closed position
and ensure that the latch is in the locked position.
Step 5. Reinstall the drive filler panel.
Step 6. Check the drive status LED to verify that the drive is operating correctly. If the yellow drive status
LED for a drive is lit continuously, that drive is faulty and must be replaced. If the green drive
activity LED is flashing, the drive is being accessed.
Note: If the server is configured for RAID operation using a ServeRAID adapter, you might have to
reconfigure your disk arrays after you install drives. See the ServeRAID adapter documentation for
additional information about RAID operation and complete instructions for using the ServeRAID
adapter.
Step 7. If you are installing additional hot-swap drives, do so now.
Step 8. Turn on the peripheral devices and the server.
Removing a CD/DVD drive
Use this information to remove a CD/DVD drive.
.
Chapter 6 Removing and replacing components
227