Table of Contents
Advertisement
Step 3.
Carefully push the media cage back into the chassis (see "Replacing the media cage" on page
143). Remember to reconnect the cables that were removed from the system board.
Step 4.
Reinstall the cover (see "Replacing the cover" on page 105).
Step 5.
Slide the server into the rack.
Step 6.
Reconnect the power cords and any cables that you removed.
Step 7.
Turn on the peripheral devices and the server.
Removing the operator information panel assembly
Use this information to remove the operator information panel assembly.
To remove the operator information panel assembly, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 100.
Step 2.
Turn off the server and peripheral devices and disconnect all power cords; then, remove the
cover (see "Removing the cover" on page 104).
Step 3.
Remove the media cage (see "Removing the media cage" on page 142).
Step 4.
Disconnect the cable from the back of the operator information panel assembly. This step applies
to all types of server configurations.
Step 5.
Remove the operator information panel assembly from the media cage.
Figure 71. Operator information panel assembly removal from media cage
Step 6.
If you are instructed to return the operator information panel assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
148
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide
Operator information panel
Advertisement
Table of Contents
Troubleshooting
