Removing The Operator Information Panel Assembly - Lenovo x3530 M4 Installation And Service Manual

Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2. Install the adapter in the new PCI riser-card assembly (see "Replacing an adapter" on page 194).
Step 3. Set any jumpers or switches on the adapter as directed by the adapter manufacturer.
Step 4. Align the PCI riser-card assembly with the PCI riser connector on the system board; then, press
down firmly until the PCI riser-card assembly is seated correctly in the connector on the system
board.
Figure 151. PCI riser-card assembly installation
Step 5. Install the cover (see "Replacing the server top cover" on page 189).
Step 6. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.

Removing the operator information panel assembly

Use the information to remove the operator information panel assembly.
To remove the operator information panel, complete the following steps.
Step 1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on
page 31.
Step 2. Turn off the server (see "Turning off the server" on page 22) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
.
Chapter 6 Removing and replacing structural parts
243