1
Media cage bezel
Figure 223. Retention bracket installation
12. Install the media cage (see "Replacing the media cage" on page 177).
13. Replace the top cover (see "Replacing the top cover" on page 144).
14. Slide the server into the rack.
15. Reconnect the power cords and any cables that you removed.
16. Turn on the peripheral devices and the server.
Removing the operator information panel assembly
Use this information to remove the operator information panel assembly.
To remove the operator information panel, complete the following steps.
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 289.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3.
Remove the top cover (see "Removing the top cover" on page 143).
Step 4.
Disconnect the cable from the back of the operator information panel assembly.
Step 5.
1
Pull up the release tab slightly and
the server.
2
Media cage
2
slide the operator information panel assembly out of
.
Chapter 5
Removing and replacing components
263