Lenovo System x3750 M4 Installation And Service Manual page 506

Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
2. Update the UEFI image.
3. Replace the system board.
Related links
– "Updating the firmware" on page 131
– "Removing the system board" on page 299
– "Replacing the system board" on page 301
• S.3050007 [S.3050007] A firmware fault has been detected in the UEFI image. : Internal UEFI
Firmware Fault Detected, System halted
Severity
Error
User Response
Complete the following steps:
1. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
2. Update the UEFI image.
3. Replace the system board.
Related links
– "Updating the firmware" on page 131
– "Removing the system board" on page 299
– "Replacing the system board" on page 301
• S.3058004 [S.3058004] A Three Strike boot failure has occurred. The system has booted with
default UEFI settings. : POST failure has occurred! System booted with default settings.
Severity
Error
User Response
Complete the following steps:
1. This event resets UEFI to the default settings for the next boot. If successful, the Setup Utility is
displayed. The original UEFI settings are still present.
2. If you did not intentionally trigger the reboots, check logs for probable cause.
3. Undo recent system changes (settings or devices added). If there were no recent system
changes, remove all options, and then remove the CMOS battery for 30 seconds to clear CMOS
contents. Verify that the system boots. Then, re-install the options one at a time to locate the
problem.
4. Check the IBM support site for an applicable service bulletin or firmware update that applies to
this error.
5. Update the UEFI firmware.
6. Replace the system board.
492
Lenovo System x3750 M4 Installation and Service Guide