Appendix A. Boot Code Display Error Codes - Lenovo System x3750 M4 Installation And Service Manual

Appendix A. Boot code display error codes

Use this information to resolve boot code error messages.
The boot code display area of the light path diagnostics panel provides an error code that indicates the point
at which the system stopped during the boot block and POST. A boot code is either a byte or a word value
that is produced by UEFI. This display will provide error codes in the event of a microprocessor error or a
power fault. In addition to the IMM log, the codes can provide suggested components to be replaced.
The following is an illustration show the boot code display area on the light path diagnostics panel:
Light Path Diagnostics
The following table lists the error codes that might display in the boot code display area that is associated
with the integrated voltage regulator power faults or microprocessor failure events. Follow the action plan
listed for the corresponding IMM events listed in this table to solve the problem. See the Appendix D
"Integrated management module II (IMM2) error messages" on page 509 for the corresponding IMM event ID
and action plan to follow and correct the problem.
Table 45. System power faults
Boot
code Message
01 5V_PGOOD
02 0_8VAUX_PGOOD
03 ENET_1_0VAUX_PGOOD
04
1_1V_PGOOD
© Copyright Lenovo 2016, and 2012, 2016
Potential defective Corresponding
component IMM Event ID
System Board 80070603-0701ffff
10G-T Card 80070603-0B01ffff
System Board 80070603-0701ffff
80070603-0701ffff
System Board
Corresponding IMM
log message
Sensor System VRD
has transitioned to
non-recoverable.
Sensor 10Gb-T VRD
has transitioned to
non-recoverable.
Sensor 10Gb-T VRD
has transitioned to
non-recoverable.
Sensor MainBrd VRD
has transitioned to
non-recoverable.
315