Installing A Usb Embedded Hypervisor Flash Device - Lenovo System x3750 M4 Installation And Service Manual

Guide
Step 5. Install the power supply that comes with the power interposer card, (see "Installing a 1400-watt or
900-watt hot-swap power supply" on page 99) or ( "Installing a 750-watt -48 volt to -60 volt dc
power supply" on page 102).
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 123.

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.
To install a hypervisor flash device, complete the following steps:
Step 1. Read the safety information and installation guidelines, see "Safety" on page v and "Installation
guidelines" on page 38.
Step 2. Turn off the server (see "Turning off the server" on page 23) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3. Remove the top cover (see "Removing the server top cover" on page 40).
Note: You might have to remove the PCIe riser-card assembly to access the USB (hypervisor)
connectors.
Step 4. Locate the USB (hypervisor) connector on the system board in which you want to install the flash
device (see "System-board internal connectors" on page 28 for the location of the connectors for
the embedded hypervisor USB flash device).
Step 5. Make sure that the lockbar on the USB (hypervisor) connector is in the unlock position (down).
Step 6. Align the USB flash device with the connector on the system board and push it into the connector
until it is firmly seated.
Step 7. Slide the lockbar up to the locked position until the lockbar is seated firmly.
Power
interposer
card
.
Chapter 2 Installing optional devices
107