To Sensor Removal And Installation; Ho2 Sensor Inspection; Ho2 Sensor Removal And Installation - Suzuki FL125S Service Manual

TO SENSOR REMOVAL AND INSTALLATION

• Remove the front frame cover. (#5-5)
• Remove the TO sensor.
• Install the TO sensor in the reverse order of removal.
NOTE:
When installing the TO sensor, the arrow mark A must be
pointed upward.

HO2 SENSOR INSPECTION

The heated oxygen sensor is installed in the exhaust pipe.
(#8-74)
HO2 SENSOR REMOVAL AND
INSTALLATION
• Remove the frame covers, left and right. (#5-7)
• Disconnect the HO2 sensor coupler 1.
• Remove the HO2 sensor 2.
"
Do not remove the HO2 sensor while it is hot.
%
* Be careful not to expose the HO2 sensor to exces-
sive shock.
* Do not use an impact wrench while removing or
installing the HO2 sensor.
* Be careful not to twist or damage the HO2 sensor
lead wires.
• Installation is in the reverse order of removal.
%
Do not apply oil or other materials to the HO2 sensor
air holes.
• Tighten the HO2 sensor to the specified torque.
+ HO2 sensor: 25 N·m (2.5 kgf-m)
FL125SDW 8-80