Inspection; Installation - Suzuki FL125S Service Manual

5-35 CHASSIS
• Disconnect the front brake lever switch lead wires 4.
• Remove the brake master cylinder 5. ($5-22)
• Remove the handlebars by removing the handlebar clamp nut
6.

INSPECTION

Inspect the handlebars for distortion or damage. If any defects
are found, replace the handlebars with a new one.

INSTALLATION

Install the handlebars in the reverse order of removal.
Pay attention to the following points:
• Tighten the handlebar clamp nut to the specified torque.
" Handlebar clamp nut: 60 N·m (6.0 kgf-m)
HANDLEBAR RIGHT SIDE PARTS
• Install the master cylinder. ($5-25)
• When installing the throttle grip case, engage the stopper A
of upper throttle case with the hole B of handlebar 1.
• Apply SUZUKI SUPER GREASE "A" to the throttle cable end
and cable drum.
* 99000-25010: SUZUKI SUPER GREASE "A"