Suzuki FL125S Service Manual page 45

• Tighten the engine sprocket bolts 1 to the specified torque.
" Drive chain sprocket bolt: 10 N·m (1.0 kgf-m)
• Install the exhaust pipe gasket 2.
#
The removed gasket must be replaced with a new gas-
ket to prevent exhaust gas leakage.
• Tighten the exhaust pipe nuts to the specified torque.
" Exhaust pipe nut: 23 N·m (2.3 kgf-m)
• Install a new exhaust gas sealer 3 into the exhaust pipe lip.
NOTE:
Exhaust gas sealer should be applied to both of the inside and
outside of the connector.
EXHAUST GAS SEALER: PERMATEX 1372
#
The removed exhaust gas sealer must be replaced
with a new exhaust pipe/muffler connector sealer to
prevent exhaust gas leakage.
(Commercially available)
ENGINE 3-8