ENGINE REASSEMBLY
Reassemble the engine in the reverse order of disassembly.
The following steps require special attention or precautionary
measures should be taken.
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling.
GEARSHIFT STOPPER PIN BOLT
• Install the gearshift stopper pin bolt 1 and tighten them to the
specified torque.
" Gearshift stopper pin bolt: 23 N·m (2.3 kgf-m)
CRANK BALANCER
• Install the crank balancer 1 and crankshaft 2 to the left
crankcase.
CRANKSHAFT
• When installing the crankshaft into the left crankcase, it is
necessary to pull its left end into the left crankcase with the
special tools.
& 09910-32812: Crankshaft installer
09910-32860: Crankshaft installer spacer
09911-11310: Attachment
#
Never fit the crankshaft into the crankcase by striking
it with a plastic mallet. Always use the special tool,
otherwise the accuracy of crankshaft alignment will be
affected.
ENGINE
3-58