Suzuki FL125S Service Manual page 114

3-77 ENGINE
• Install the cylinder head assembly 3.
• Install the cylinder head nut gaskets 4.
#
The removed nut gaskets must be replaced with new
ones to prevent oil leakage.
• Tighten the cylinder head nut diagonally to the specified
torque.
" Cylinder head nut: 25 N·m (2.5 kgf-m)
• Tighten the cylinder head base bolts to the specified torque.
" Cylinder head base bolt: 10 N·m (1.0 kgf-m)
CAMSHAFT SPROCKET/AUTOMATIC DECOMP.
• Turn the generator rotor until the line A on the generator rotor
is aligned with the center of the hole in the generator cover.
#
If the generator rotor is turned without drawing the
cam chain upward, the cam chain will be caught
between the crankcase and camshaft sprocket.
• Install the locating pin 1 and angle pin 2.