Suzuki FL125S Service Manual page 103

GEARSHIFT CLUTCH
• Install the spacer 1.
NOTE:
Apply engine oil to the both surfaces of the spacer.
• Install the primary driven gear 2.
NOTE:
When engaging the primary drive and driven gears, rotate the
primary driven gear counterclockwise.
• Install the clutch pressure disc 3 to the clutch sleeve hub 4
while aligning the marks A on the clutch pressure disc 3 with
the marks B on the clutch sleeve hub 4.
• Install the gearshift clutch assembly 5, washer 6 and wave
washer 7.
• Install the clutch sleeve hub nut 8.
• Hold the gearshift clutch assembly 5 with the special tool and
tighten the clutch sleeve hub nut 8 to the specified torque.
" Clutch sleeve hub nut: 50 N·m (5.0 kgf-m)
& 09920-53760: Clutch sleeve hub holder
ENGINE 3-66