Suzuki FL125S Service Manual page 313

USE OF SDS DIAGNOSTIC PROCEDURES
NOTE:
* Do not disconnect the coupler from ECM, battery cable from
battery, ECM ground wire from engine or main fuse before
confirming the DTC (Diagnostic Trouble Code) stored in mem-
ory. Such disconnection will erase the memorized information
in ECM memory.
* DTC stored in ECM memory can be checked by SDS.
* Be sure to read "PRECAUTIONS IN SERVICING" ( # 8-12)
before inspection and observe what is written there.
• Remove the battery box lid. (#6-9)
• Set up the SDS tool. (Refer to the SDS operation manual for
further details.)
• Read the DTC (Diagnostic Trouble Code) and show data
when trouble (displaying data at the time of DTC) according to
instructions displayed on SDS.
• SDS is not only used for detecting DTC but also for reproduc-
ing and checking on screen the failure condition as described
by customers using the trigger.
• How to use trigger. (Refer to the SDS operation manual for
further details.)
$ 09904-41010: SDS set tool
99565-01010-011: CD-ROM Ver. 11
FL125SDW 8-38