Offset Stitching (With Overlap Back Tacking) - Mitsubishi Electric PLK-G-CU-20 Technical Manual

11.Offset stitching (with overlap back tacking)

[Example] The following type of sewing data will be created.
Operation details
(1)Setting the input method
►
Set the feed data from the home position H to the A
point with the procedures for broken line input, and
open the Input Method Setting screen.
►
Press Broken Line Input
►
Press Offset
►
Press Overlap Back Tacking
►
Set the application input details. Press
(2)Setting the offset details
►
The details are set on this screen.
(Press
The offset amount can be set in 0.1mm increments
between 0 and 20mm.
►
After inputting the details, press
data.
(3)Setting the back tacking details
►
After returning to the Input Method Setting screen,
press the back tacking details setting icon
.
.
.
, and set the distance to 5.0.)
to set the
Input offset stitching with overlap back tacking as a
broken line. (Set the offset distance to "5.0 mm",
direction to "right", overlap back tacking mode to "1",
and number of stitches to "3".)
(The bold section indicates the overlap back tacking
section.)
(The dotted line (
line (position before offset.))
.
.
[7] - 32
indicates the actual input
- - - - - - -)