Modifying A Block 3 (Zigzag Input) - Mitsubishi Electric PLK-J Series Technical Manual

17. Modifying a block 3 (Zigzag input)

[Example] The section between the A point and B point in the following type of stitching data is modified to
a zigzag pattern.
Operation details
(1) Selecting block modification
►Enter the modification mode. (Refer to Page [11]-2)
►Press Stitch Data Change
Block Modify
►Press
(2) Selecting the input type
►Press Zigzag
►Set the deflection width, feed amount and creation
direction.
Set the deflection width to 5.0mm, feed amount to 3.0mm,
and the creation direction to right (R).
Refer to page [7]-35 "12.Zigzag stitching (with
Note
overlap back tacking)" for details on the deflection
width, feed amount and creation direction.
►Press
settings will be canceled.)
(3) Determining the block modification range (start point)
►Using Jog
(A point)
►Press
.
and
.
to open the next screen.
.
to set the data. (At this time, if
determine the start point position.
→
is pressed, the deflection width and feed amount
[11]‐３２