Mesh Base Setting; Mesh Client Setting - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

5-44 WS2000 Wireless Switch System Reference Guide

5.14.1 Mesh Base Setting

Use the Mesh Base Settings area of the Mess Setting screen to set up the device as a Mesh Base device.
To do so:
1. Check the Mesh Base
2. Enter the maximum number of clients this Mesh Base device can handle simultaneously. The maximum
number of client devices that can be handled is 6.
3. Click Apply

5.14.2 Mesh Client Setting

Use the Mesh Client Setting area of the Mesh Setting screen to set up the device as a Mesh Client device.
To do so:
1. Check the Mesh Client
2. Select the Wirless LAN this device will connect to from the
3. To enable a Mesh Client device to automatically select the best Mesh Base to connect to, check the
Automatic Base Selection
4. The Available Base Bridge List
the channel they operate in, and the Radio Signal Strength Indicator (RSSI) value.
Use the Refresh
5. The Preferred Base Bridge List
priority of the Mesh Base can be modified by moving the device up or down the
List. To change the priority of a Mesh Base, use the
available when
6. To add a new Mesh Base to the
where you can enter the MAC address of the Mesh Base and the required priority. This button is not
available when
7. To remove a Mesh Base from the
removed from the list. This button is not available when
8. To remove all devices from the
are removed from the list. This button is not available when
9. Click Apply
box to set the device as a Mesh Base.
button to save changes.
box to set the device as a Mesh Client.
box.
is a list of all available Mesh Base devices with their MAC address,
button to refresh the
is a list of Mesh Bases that the device prefers to connect to. The
Automatic Base Selection
Preferred Base Bridge
Automatic Base Selection
Preferred Base Bridge
Preferred Base Bridge
button to save changes made to Mesh configuration.
Mesh WLAN
Available Base Bridge List.
Up and Down
is enabled.
List, click the
is enabled.
List, click the
Automatic Base Selection
List, click the
Automatic Base Selection
drop-down.
Preferred Base Bridge
buttons. These buttons are not
Add button. A dialog opens
Remove button. The device is
is enabled.
Remove All button. All the device
is enabled.