Host Computer - Jbics Interconnection (P2); Power Connector (P1) - Motorola M68ICS08JB User Manual

2.2.4 Host Computer - JBICS Interconnection (P2)

2.2.5 Power Connector (P1)

M68ICS08JB In-Circuit Simulator
MOTOROLA
Table 2-2 is a quick reference for defining the cable/connector setup to use with
the JBICS.
Table 2-2. Cable/Connector Options for MCUs
MCU Flex Cable
MC68HC90
J1 and J2
8JB8
The host computer to JBICS interface is via the single system connector P2,
which is a 9-pin, D-type connector (Amp part number AMP-9726-A)
(Figure 2-1), mounted on the top side of the board.
Connection requires the cable assembly supplied with your JBICS kit, a
DB9-male-to-female, 6-ft. (3 m) long serial cable.
Figure 2-1. P2 Host Computer to JBICS Interconnection
Connect +5-Vdc power directly to the JBICS via connector P1 (Figure 2-2)
using the provided power supply.
+5 Vdc
Figure 2-2. P1 Power Connector
Preparation and Installation
DIP
Emulation
Cable
J3
1
6
RXD 2
7
TXD 3
8
4
DTR
9
GND 5
Preparation and Installation
Hardware Preparation
DIP
MON08
Emulation
Cable
Cable
J4 J5
GND
User's Manual
23