To Install The Fpd Vent Tube And Cover - Agilent Technologies 7820A Manual

13
Maintaining the G3435A/G3436A FPD

To Install the FPD Vent Tube and Cover

266
Gather the following:
1
• T-20 Torx screwdriver
• 9/16-inch wrench
Install the cover.
2
Single-wavelength detector:
a Start the two screws on the right side of the cover.
b Start and tighten the screws at the base on the left side.
c Tighten the screws on the right side.
3 Install the vent tube assembly.
Reconnect the flexible tubing to the vent tube assembly and
4
route the open end to waste.
Close the FPD cover.
5
Maintaining Your GC