To Replace The Fid Collector Assembly - Agilent Technologies 7820A Manual

8
Maintaining the FID

To Replace the FID Collector Assembly

C AU TI O N
158
Gather the following:
1
• New FID collector assembly. (See
for the FID" on page 146.)
• T-20 Torx screwdriver
1/4-inch nut driver
•
• Tweezers
• Lint-free gloves
To avoid contaminating the FID, wear clean, lint-free gloves when
handling the collector assembly.
Load the GC maintenance method
2
become ready.
3 Disconnect the ignitor cable assembly.
4 Remove the three screws holding the collector assembly to
the mounting pallet.
"Consumables and Parts
and wait for the GC to
Maintaining Your GC