To Install The Fpd Vent Tube And Cover - Agilent Technologies Agilent 7890 Series Maintenance Manual

16
Maintaining the G3435A/G3436A FPD

To Install the FPD Vent Tube and Cover

322
1 Gather the following:
• T- 20 Torx screwdriver
• 9/16- inch wrench
2 Install the cover.
Single- wavelength detector:
Start the two screws on the right side of the cover.
a
Start and tighten the screws at the base on the left
b
side.
Tighten the screws on the right side.
c
Dual- wavelength detector: Install the cover (two screws).
3 Install the vent tube assembly.
4 Reconnect the flexible tubing to the vent tube assembly
and route the open end to waste.
Close the FPD cover.
5
Maintaining Your GC