• Do not remove the wiper cleaner from the bracket.
• Only clean the front surface on the wiper cleaner's
wiper. (You do not need to clean the rear surface.)
• Do not remove the absorbent material in the
absorbent case.
• After the wiper cleaner cleaning, make sure that
the cleaner is not facing up.
OK
Set the wiper at the original position.
7
• Insert the wiper by holding the protrusions at its
both ends.
Projection
Clean the cap rubber.
8
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
Wipe off so that maintenance solution for
maintenance will not remain.
Cap rubber
• After cleaning the cap rubber, check to make sure
the cap slider is not tilted.
If it is tilted, move the slider block left and right to
fix its tilt.
Cap slider
NG
Slider block
Press the
9
Close the front cover then press the
10
key.
• After its initial operation, the machine returns to
step1.
Washing the Head Nozzle
Press
(MENU)
1
in LOCAL.
• MAINTENANCE MENU will be displayed.
Press
.
2
• "STATION" will be selected.
Press
to select "NOZZLE
3
WASH", and press the
Press
to select the washing
4
head, and press the
When "WIPER CLEANING" appears on the
5
display, open the front cover.
Clean the wiper and the bracket, and press
6
the
key.
(1) Open the right maintenance cover then pull
out it by holding projections at both ends of
the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
Chapter 4 Maintenance
key after the cleaning.
key.
key.
Projection
4-7
1
2
2
4
5
6