Chapter 3 Setup
Setting of MAPS4
The MAPS (Mimaki Advanced PassSystem) function to
disperse the pass boundary to make the feeding stripes
less visible.
• Changing the MAPS4 settings may change the
color tone. Check the effects before use.
• MAPS may not be effective depending on image to
be printed. Use it after checking effect in advance.
Conditions disabling MAPS function
The MAPS function may be disabled under the follow-
ing conditions. In addition, the MAPS may not be effec-
tive, depending on the image to be printed.
4-colors ink set
Resolution
Pass
360x 360
1 pass Normal speed
540x 360
2 pass
720x 720
4 pass
720x 1080
6 pass
6-colors ink set
Resolution
Pass
360x 360
2 pass Normal speed
540x 360
4 pass
720x 720
8 pass
720x 1080
12 pass
Setting MAPS4 Function (AUTO)
Press
1
Press
2
and press the
• SETUP MENU will be displayed.
Press
3
Press
4
press the
Press
5
press the
• To select "MANUAL" for the setting, refer to P.3-10
"Setting MAPS4 Function (MANUAL)".
Press
6
MODE", and press the
Press
7
(STANDARD/QUALITY), and press the
key.
STANDARD : Prints in standard quality mode.?
: Prints in high quality mode.
QUALITY
3-10
Scan speed
MAPS MODE
High speed
Standard
High speed
High speed
Scan speed
MAPS MODE
High speed
Standard
High speed
High speed
in LOCAL.
(MENU)
to select SETUP 1 to 4,
key.
(>>) twice.
to select "MAPS4" , and
key.
to select "AUTO", and
key.
to select the "MAPS
key.
to select the setting value
"Prints more slowly than when
"STANDARD" is selected.
Press the
8
end the setting.
Setting MAPS4 Function (MANUAL)
Press
(MENU)
1
Press
to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press
(>>) twice.
3
Press
to select "MAPS4" , and
4
press the
Press
to select "MANUAL", and
5
press the
• To select "AUTO" for the setting, refer to P.3-10
"Setting MAPS4 Function (AUTO)".
Press
to select the "Speed" (50
6
to 100%), and press the
• Select a speed for printing. By using standard
quality printing as reference, set in the direction of
minus (-) to decrease the print speed, and set in
the direction of plus (+) to increase the print
speed.
• If the speed is changed, NOZZLE RECOVERY
(
P.3-27) may not become effective. Check in
advance before use.
Press
to select the "Smoothing
7
Lv.", and press the
Press
to change the smoothing
8
level, and press the
• Set Value : 0 to 100% (set in units of 5%)
• The MAPS4 effect become strong as the set value
increase, and become weak as the set value decrease.
Press the
9
end the setting.
key several times to
in LOCAL.
key.
key.
key.
key.
key.
key.
key several times to