MIMAKI TS300P-1800 Operation Manual page 110

Chapter5 Troubleshooting
Message
ERROR 04
PARAM ROM
ERROR d01
HCB POWER [1234]
ERROR d02
HCB COMMON [1234]
ERROR d03
HCB HARD [1234]
ERROR d04
HCB CMD [1234]
ERROR d05
HCB WFM [1234]
ERROR d06
HCB VUP [1234]
ERROR d07
HCB FAN [1234]
ERROR d08
HCB UKNWN [1234]
ERROR d09
HD MEMORY [1234]
ERROR d0a
HCB BUSY [1234]
SYSTEM HALT
Message
SYSTEM HALT (*)
000 : MESSAGE
SYSTEM HALT (*)
406 : WIPER ORG
5-12
Cause
An error occurred in the main PCB
FROM.
An error occurred in the power supply of
the HCB PCB.
An error was detected in the HCB PCB.
An error was detected in the HCB PCB
communication.
An error was detected in the waveform
being printed.
A failure to update the HCB PCB was
detected.
An error occurred in the HCB board fan.
An unknown error was detected from the
HCB board.
An abnormality was detected from the
head built-in memory.
An error occurred in the communication
between the HCB board and the slider P
board.
• Turn off the main power to the machine and turn it on after a while.
If the same error message appears again, check the number and contact your local dis-
tributor to call for service. ("000" is the error No.)
• Perform cleaning around the wiper.
• Turn off the main power to the machine and turn it on after a while.
If the same error message appears again, check the number and contact your local dis-
tributor to call for service.
Solution
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
Solution