Connecting The Power Cable - MIMAKI TS300P-1800 Operation Manual

Chapter 1 Before Use
 If connecting via a switching hub
Switching hub
If the PC or device connected to the printer is not
1000BASE-T, you cannot perform printing.
After connecting, check the following.
(1) Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
• Check that "1000Mbps" is displayed for the LAN status
item.
• If "100Mbps", "10Mbps", or "No connect" is
displayed, you cannot print using the LAN.
• If "100Mbps" or "10Mbps" is displayed, you can
use event mail (
mail function").
INFORMATION
LAN Status
(2) Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
Color State
Lighting Connected with 1000BASE-T
Green
OFF Connected without 1000BASE-T
Lighting Link-up
Yellow Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000Mbps. Check the specifications
of the PC, device, and cables.
1-10
Chapter3 " Setting event
1000Mbps
Condition

Connecting the power cable

Insert the power cable into an inlet of the
1
machine.
Power cable
Secure a cable band.
2
• Secure the cable with the cable band attached to
this machine.
Insert the power plug into a plug socket.
3
Power plug
• Do not use any power cables other than the
attached power cable.
• Be sure to connect the power cable to the outlet
near this machine, and make sure that the power
cable can be easily removed.
• Connect the power cable to the grounded
outlet.Otherwise, it may result in fire or an electric
shock.
Inlet
Cable band
Socket