Maintenance - MIMAKI TS300P-1800 Operation Manual

This chapter
describes the items required to use this machine more comfortably, which are the
methods for the daily care, the maintenance of the ink cartridges etc.
Maintenance ................................................. 4-2
Precautions for Maintenance ...................... 4-2
About Cleaning Solution.............................. 4-2
Cleaning the Exterior Surfaces ................... 4-2
Cleaning the Platen ..................................... 4-2
Cleaning the Media Sensor ......................... 4-2
Cleaning the Media Press ........................... 4-3
About MAINTENANCE MENU ...................... 4-4
MAINTENANCE MENUs at-a-glance .......... 4-5
Maintaining the Capping Station ................... 4-6
Cleaning the Wiper and Cap ....................... 4-6
Washing the Head Nozzle ........................... 4-7
Washing the Ink Discharge Passage .......... 4-9
When the Machine Is Not Used for a Long
Time ......................................................... 4-10
Cleaning the Ink Head and the Area
around It ...................................................... 4-12
Nozzle Recovery Function .............................. 4-13

Maintenance

Reset the set value ....................................4-14
Check the condition for which nozzle
recovery cannot be performed ...................4-14
Enabling or disabling nozzle recovery
during a test print .......................................4-14
Automatic Maintenance Function ................4-15
Setting the Refreshing Intervals .................4-15
Setting the Tube Wash Intervals ................4-15
Setting the Cleaning Intervals and Type ....4-15
Suspend the nozzle cleaning .....................4-16
Fill up Ink .....................................................4-16
Replacing consumables ..............................4-16
Replacing the wiper ...................................4-16
If a Waste Ink Tank Confirmation
Message Appears ......................................4-17
Replace the waste ink tank with another ...4-18
Replacing the Cutter Blade ........................4-19
Chapter 4