Washing The Head Nozzle - MIMAKI JV300-130 A Operation Manual

Chapter 4 Maintenance
Set the wiper at the original position.
7
• Insert the wiper by holding the protrusions at its
both ends.
Clean the cap rubber.
8
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
Wipe off so that maintenance solution for
maintenance will not remain.
Cap rubber
Press the
9
Close the front cover then press the
10
key.
• After its initial operation, the machine returns to
step1.

Washing the Head Nozzle

Press the
1
key in LOCAL.
• MAINTENANCE MENU will be displayed.
Press the
2
• "STATION" will be selected.
Press , and press the
3
• "NOZZLE WASH" will be selected and the
carriage will move onto the platen.
Open the front cover.
4
Clean the wiper and the bracket, and press
5
the key.
(1) Open the right maintenance cover then pull out it
by holding projections at both ends of the wiper.
4-8
Projection
key after the cleaning.
(MENU)
key.
key.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance. (SPC-0137
• Wipe off so that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
Clean the cap rubber , and press the
6
key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
Fill up the cap with cleaning solution for
7
maintenance．
• Suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
Close the front cover, and press the
8
key.
Projection