Basic Operations - MIMAKI TS300P-1800 Operation Manual

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow ....................................................... 2-2
Turning the Power ON/OFF .......................... 2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media ............................................. 2-4
Adjusting the Head Height .......................... 2-4
Setting a roll media ..................................... 2-5
Using the tension bar to set the roll media .. 2-8
Take-up device .......................................... 2-10
Setting leaf media ..................................... 2-14
Changing the printing origin ...................... 2-15
Preparing for the Heaters ............................ 2-16
Changing the Temperature Settings for the
Heaters ...................................................... 2-16
Test Printing ................................................ 2-16
Test Printing .............................................. 2-16
Head Cleaning ............................................ 2-17

Basic Operations

About head cleaning ..................................2-17
Perform head cleaning depending on the test
printing result .............................................2-17
Setting of Media Correction .........................2-18
Setting of Media Correction ......................2-18
If the Positions of Dots Shift... .....................2-18
Printing Data ...............................................2-19
Starting a Printing Operation .....................2-19
Stopping a Printing Operation ....................2-19
Deleting Received Data (Data Clear) ........2-19
Behavior after printing has been completed ..2-
19
Cutting a media ..........................................2-20
Chapter 2