MIMAKI TS300P-1800 Operation Manual page 37

Entering the media remaining amount
When [MEDIA RESIDUAL] of the machine setup is "ON"
P.3-17
( ), the screen for entering media remaining
amount is displayed after detecting the media width.
Display the screen for entering media
1
remaining amount.
MEDIA REMAIN
Enter the MEDIA REMAIN
50.0m
POST1 POST2
30° /40°30° /35°40° /50°
Press to enter the media
2
remaining amount.
Press the
3
About the media residual print
When [MEDIA RESIDUAL] of the machine setup is "ON"
( P.3-17), You can print a list of print the current date
and media remaining.
In Local, Press
1
• It enters into the origin setting mode.
Press the
2
• Appear the confirmation
remaining print.
Press the
3
• Media residual print starts.
Setting of the manual media width
setting
MEDIA DETECT
When [ ] of the machine setup is
P.3-17
"MANUAL" ( ), set the media width in the
following method.
Display the "MEDIA DETECT" screen.
1
MEDIA DETECT
PRINT AREA [WIDTH] MANUAL
POST1 POST2
30° /40°30° /35°40° /50°
Select the print area setting method.
2
• When setting the print area, use either "Manual"
to set the right and left edge of the media using
the jog key, or "Media width input mode" to set the
FAN
key.
.
key.
screen of media
key.
FAN
Chapter 2 Basic Operation
right edge of the media after inputting media
width.
• When "Manual" is selected, proceed to Step 3.
And when "Media width entering mode" is
selected, proceed to below.
(1) Press [][], and enter the media width.
(2) Press the [ENTER] key, and perform after
step3.
Press to set a light point of the
3
LED pointer to the right edge position of
the media.
• Align the light of the LED pointer incorporated in
the carriage to the right edge of the media.
RIGHT EDGE POSITION
POST1 POST2
30° /40°30° /35°40° /50°
Press the key.
4
• Next, the screen to enter the left edge position of
the media is displayed.
When "Media width entering mode" is selected on
step 2, this setting is end without display this
screen.
LEFT EDGE POSITION
POST1 POST2
30° /40°30° /35°40° /50°
Press to set a light point of the
5
LED pointer to the left edge position of the
media.
• In the same manner as in step 3, align the light of
the LED pointer to the left edge of the media.
Press the key.
6
• Be careful not to set the position beyond the media
range, as it may cause printing or cutting outside
the media.
FAN
2
FAN
2
2
5
6
2-9