MIMAKI TS300P-1800 Operation Manual page 24

Chapter 1 Before Use
Attach the 2L eco case to the base.
4
• Ink is supplied to the printer connecting to the 2L
eco case.
• After 1 or 2 minutes, EMPTY lamp on the
connected printer goes out.
• Push the 2L eco case all the way in. If not, it may
not supply ink.
1-12
Replacing the 2L Ink Pack
Perform as follows when [INK END] or [INK NEAR END]
is displayed on the display.
• When exchanging 2L ink pack, be sure to wear
goggles and gloves. Ink may spatter and get in
your eyes accidentally.
• Although approximately 10 cc of ink remains in
the ink pack after use, the pack is filled so that the
actual amount used is two liters.
 When [INK END] is displayed
Push the lever of the base down, and
1
remove the 2L eco case.
• When replacing the 2L ink pack, replace the male
connector absorbent (attachment) periodically to
prevent the stain in the base.
• Replace the absorbent
every five to ten times
of the 2L ink pack
replacement.
• When replacing the
absorbent, be sure to
wear the attached
goggles and gloves.
Remove the IC chip.
2
Open the 2L eco case, then replace the 2L
3
ink pack.
• Keep the IC chip removed in the step 2 with used
2L ink packs.
(Not to mix with an IC chip of a new ink pack)
IC chip