MIMAKI TS300P-1800 Operation Manual page 103

Message
Wash liqid cartridge none
Wash liqid end
NCU SENSOR LEVEL LOW
NCU Sens Adj Err H
NCU Sens Adj Err L
Nozzle Missing
Print Stopped
NCU FLUSH POS
Nozzle check OFF
NCU CENTER POS
Nozzle check OFF
NCU SN ADJST
Nozzle check OFF
NCU NZK CHK (HW)
Nozzle check OFF
NCU NZK CHK (MARK)
Nozzle check OFF
NCU CONNECT
REPLACE NCU
REPLACE NCU INK PAD
NCU ERROR
Nozzle check OFF
ADJUST HEAD HEIGHT
Cause
The maintenance washing liquid car-
tridge is not set.
Wiper washing and pump tube washing
cannot be executed. (Auto maintenance
operation)
There is no remaining maintenance
washing liquid.
Wiper washing and pump tube washing
cannot be executed. (Auto maintenance
operation)
The NCU sensor sensitivity is falling.
The sensitivity level of the sensor cannot
be adjusted.
Because the nozzle check found nozzles
missing, printing was stopped.
Because an NCU-related error occurred
during nozzle check, printing was
stopped and the nozzle check function
was turned OFF.
The NCU unit is not connected.
The nozzle check function cannot be
used.
The NCU sensor sensitivity is too low to
correctly judge nozzle missing.
The nozzle check function cannot be
used.
The NCU ink pad is full.
Because an NCU-related error occurred
during nozzle check, printing was
stopped and the nozzle check function
was turned OFF.
The head height setting saved in the
machine and the current head height do
not match.
Chapter5 Troubleshooting
Solution
Set the maintenance washing liquid cartridge.
Replace with a new washing liquid cartridge.
Replacement of the NCU is recommended.
Contact our service desk or your local distrib-
utor to call for service.
Perform head cleaning ( P.2-17) and deal
with the nozzles clogging (
• Take steps according to the explanation for
"ERROR 655 / NCU FLUSH POS".
• Take steps according to the explanation for
"ERROR 654 / NCU CENTER POS".
• Take steps according to the explanation for
"ERROR 656 / NCU SN ADJST".
• Take steps according to the explanation for
"ERROR 652 / NCU NZK CHK (HW)".
• Take steps according to the explanation for
"ERROR 653 /NCU NZK CHK (MARK)".
• Turn the main power OFF, wait a while, and
then turn it ON again.
If the same error message appears, contact
our service desk or your local distributor to
call for service.
• NCU replacement is necessary.
• Contact our service desk or your local dis-
tributor to call for service.
• It is necessary to replace the NCU ink pad.
• Contact our service desk or your local dis-
tributor to call for service.
• Contact our service desk or your local dis-
tributor to call for service.
• Set the head height. ( P.2-4)
1
P.5-3).
2
2
2
5
6
5-5