Setting Of Media Correction - MIMAKI TS300P-1800 Operation Manual

• Settings of Temporary will be saved to the location
selected in step 5.
Press the
7
end the setting.
Reset the registered contents
Reset the contents registered to SETUP 1 to 4.
Press (MENU)
1
Press to select SETUP 1 to 4 to
2
be reset and press the
• SETUP MENU will be displayed.
Press ( <<).
3
Press to select "RESET
4
SETTING", and press the
• Confirmation screen of reset settings will be
displayed.
Press the
5
end the setting.

Setting of Media Correction

Correct the media feed amount to match the type of
media you are using.
If the correction value is not appropriate, stripes may
appear on the printed image, thus resulting in a poor
printing.
• On completion of [MEDIA COMP.] during use of a roll
media, the media returns to the printing origin. Then the
roll media in the rear of this machine will slacken.
Before printing, take up the slack in the roll media by
hand; a loose roll media can result in an inferior image
quality.
• When printing with a take-up device, set the media first
and then perform media correction.
A pattern for media correction is printed and a media-
feeding rate is corrected.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is
obtained in the boundary between the two bands.
Second band
First band
Set a media. (
1
key several times to
in LOCAL.
key.
key.
key several times to
P.2-4)
Press
(MENU)
2
Press to select SETUP 1 to 4,
3
and press the
• SETUP MENU will be displayed.
Press to select "FEED COMP",
4
and press the
Press the
5
correction pattern.
Check the correction pattern and enter a
6
correction value.
• A screen for entering the correction value will be
displayed.
• Enter a correction value in "+":
The boundary between the two bands is widened.
• Enter a correction value in "-":
The boundary between the two bands is
narrowed.
• When you change the correction value by "30", the
width of the boundary changes by about 0.1 mm.
Press the
7
• Print a correction pattern again and check it.
• When media correction is needed, perform the
operation in Step 7 to make correction.
Press the
8
end the setting.
Correcting Media-feeding during Printing
A media-feeding rate can be corrected even in the remote
mode or when image data is printed.
Press
(ADJUST)
1
Remote.
Press to enter a corrected
2
feeding rate.
• Corrected feeding rate: -9999 to 9999
• The value entered here is reflected in the
corrected feeding rate soon.
Press the
3
• key. The changed value is registered.
• When you press the [ENTER] key instead of the
[END] key, the value entered here will be valid
temporarily. (When you perform media detection
again or turn the power OFF, the correction value
is cleared.)
Chapter 3 Setup
in LOCAL.
key.
key.
key twice to print a
key.
key several times to
in the
key twice .
3-5
1
2
3
4
5
6