Setting The Optional Heater; Setting Of Logical Seek - MIMAKI TS300P-1800 Operation Manual

Setting the Optional heater

For details about the optional drying heater, refer to the
separate document, "OPT-J0388 Heater 1800 Operation
Manual."
Press
(MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press to select "OPTION
3
HEATER", and press the
• "OPTION HEATER" is indicated only when the
optional heater unit is connected.
Press to select "FAN HEATER",
4
and press the
Press to select the power of
5
heater, and press the
• Set value: OFF/LOW/MID/HIGH
• Heating of the heater starts by selecting any set
other than "OFF".
Press to select "STANDBY
6
TIME", and press the
Press to set the standby time,
7
and press the
• Set value: none, 0 to 90 inutes
• Set the time from the end of printing to the start of
decreasing of the heater unit to "LOW" status.
• When receiving a print data while the temperature
was down, the printing will start automatically after
the temperature goes up to the pre-set value.
• If setting the value as "none", the heater will not
go down to "LOW".
Press to serect "OFFTIME" , and
8
press the
Press , set the time until the
9
heater to be OFF after printing, and press
the key.
• Set value: none, 0 to 90 inutes
• If the "STANDBY TIME" has been set in step 7,
the heater will be turned OFF after erapsing
"STANDBY TIME and the time set here."
Press the
10
end the setting.
in LOCAL.
key.
key.
key.
key.
key.
key.
key.
key several times to

Setting of Logical Seek

The head's operation varies depending on the LOGICAL
SEEK settings, as shown in the figure below.
Movement of heads when LOGICAL seek is OFF
UNI-DIRECTIONAL
Media
Print erea
Red arrow :
Movement of head
Movement of heads when LOGICAL seek is ON
UNI-DIRECTIONAL
Media
Print erea
Red arrow :
Movement of head
Press
(MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press to select "LOGICAL
3
SEEK", and press the
Press to select a set value, and
4
press the
• Set value : HOST / ON / OFF
Press the
5
end the setting.
Chapter 3 Setup
BI-DIRECTIONAL
Media
BI-DIRECTIONAL
Media
in LOCAL.
key.
key.
key.
key several times to
3-7
1
2
3
4
5
6