MIMAKI TS300P-1800 Operation Manual page 104

Chapter5 Troubleshooting
Ink Error
Ink error is displayed also in the local guidance. (
Message
WRONG INK IC
INK TYPE
INK COLOR
WRONG CARTRIDGE
NO CARTRIDGE
INK END
INK NEAR END
Expiration
Expiration:1MONTH
Expiration:2MONTH
ERROR 63c
INK REMAIN ZERO
5-6
P.3-29)
Cause
The IC chip of the ink pack cannot be
read normally.
The ink of the ink pack is different in type
from the ink currently supplied.
The ink of the ink pack is different in
color from the ink currently supplied.
An error occurred in the IC chip informa-
tion of the ink pack.
An IC chip has not been installed in the
slot.
The ink of the ink pack has been com-
pletely used up.
There is only a little bit of ink left in the
ink pack.
The ink of the ink pack has been nearly
used up.
The specified expiration date of an ink
pack has passed.
The expiration date of an ink pack has
passed (one month has passed after the
specified expiration date).
The expiration date of an ink pack has
passed (two months have passed after
the specified expiration date).
Solution
• Remove the ink IC chip generating the warn-
ing once and install it again.
• If the same warning message still appears,
contact your local distributor to call for ser-
vice.
• Check the ink type of the cartridge generat-
ing the warning.
• Check the ink color of the cartridge generat-
ing the warning.
• Check the cartridge generating the warning.
• Make sure there is no nozzle clogging
(Especially, white ink).
• Install an appropriate ink IC chip in the slot
generating the warning.
• Replace the ink pack generating the warning
with a new one.
• The ink will soon be used up.
Be careful.
• Replace the cartridge generating the warn-
ing with a new one.
However, it can be used until the month after
next.
• The expiration date has passed.
However, you can use it until the end of the
following month.
• One month has passed after the expiration
date.
• Replace the ink pack with a new one.