MIMAKI TS300P-1800 Operation Manual page 107

Message
ERROR 304
USB INIT ERR
ERROR 305
USB TIME OUT
ERROR 307
MCFD File IF Error
ERROR 401
MOTOR X
ERROR 402
MOTOR Y
ERROR 403
X CURRENT
ERROR 404
Y CURRENT
ERROR 423
TAKE-UP TENSION-BAR
ERROR 425
Take-UP WRONG
ERROR 429
Take-UP LimitDETECT
ERROR 44f
Take-UP Roll Sns Err
ERROR 505
MEDIA JAM
ERROR 509
HDC POSCNT
ERROR 50a
Y ORIGIN
ERROR 50f
L-SCALE BLACK
ERROR 52c
MEDIA WIDTH SENSOR
ERROR 516
MEDIA SET POSITION R
Cause
An error occurred in the communication
of USB.
An error occurred during the access to
the printing condition data.
An excessive load was applied to the X
motor.
An excessive load was applied to the Y
motor.
An error due to an excessive current of
the X motor was detected.
An error due to an excessive current of
the Y motor was detected.
Error in the take-up tension bar.
• The tension bar origin could not be
found.
• No change could be seen in the ten-
sion bar angle.
A problem has occurred in the take-up
tension bar.
• The tension bar control position has
deviated from the lowest point for a
certain period.
Limit position of the take-up tension bar
has been detected.
• The tension bar control position has
deviated from the highest point for a
certain period.
Roller sensor abnormality
• The roller sensor cannot be correctly
read.
The media jam occurs.
An error occurred in the control position.
Y-origin could not be detected.
Abnormal linear scale.
The media width could not be correctly
read.
The media is set outside the proper
area.
Chapter5 Troubleshooting
Solution
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Check the set state of the media.
• Make sure that the media can be wound
using the manual SW. Also, make sure that
the tension bar rises.
If it does not rise, adjust the counterweight.
( P.2-11, P.2-12)
• Confirm that the take-up unit of machine
setup and take-up tension bar setting are
ON. ( P.3-16)
• Check the set state of the media.
• Confirm that the winding unit operates using
the manual SW.
• Remove the media and reset it.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
• Check the media set position. (
• Clean the media sensor. (
• Turn the main power OFF, wait a while, and
then turn it ON again.
• Check the media set position. (
1
2
2
2
5
P.2-4)
P.4-2)
P.2-5)
6
5-9