Printing Data; Starting A Printing Operation; Stopping A Printing Operation; Deleting Received Data (Data Clear) - MIMAKI TS300P-1800 Operation Manual

Printing Data

Starting a Printing Operation

• When using a roll media, rewind the media by
hand before printing so that it is not loose.When
the roll media has not been rewound tightly, it may
cause the image quality to deteriorate.
Setting a Media (
1
Press (REMOTE) in LOCAL.
2
• The screen changes to REMOTE, and data can
be received from the PC.
Transmit data to be printed from the PC.
3
• The status indicator lamp blinks and the printing
conditions are displayed.
• For the method of data transmission, see the
instruction manual for the output software.
Resolution : 360 /540 /720 /1080 DPI
The current setting number.
REMOTE <Setup 1>
720x1080 16p / Bi / Hi / Vd
WF1 / S / NRS 0.0m
POST1 POST2 FAN
30° /40°30° /35°40° /50°
Wavef
Operating status of the nozzle recovery.
OFF : Print mode without registration or
recovery inoperable.
NRS : During operation
(possible to recover all nozzles).
: During operation (some of the nozzle
NRS
recovery is unfeasible)
MAPS4 setting
S : AUTO (Standard)
Q : AUTO (Quality)
M : MANUAL
P.2-4)
16p : Number of passes
Bi : Scan direction
Uni/ Unidirectional
Bi/ Bidirectional
Hi : Scanning speed
Std/ Standard speed
Hi/ Double speed
Vd : Data type
Vd/ Variable data
Nd/ Normal data
The length of media
printed
Chapter 2 Basic Operation
Start printing.
4
• The printing speed may change, depending on
the width of the set media or the position of the
print origin even when the same data is printed.
This is because of a difference in resolution.

Stopping a Printing Operation

Perform the following operation when stopping a printing
operation halfway.
Press the
1
• The printing operation stops.
• Interrupt data sending at the PC side during the
data is sent from the PC.
• Printing restarts from the interrupted data by
repressing the [REMOTE] key.

Deleting Received Data (Data Clear)

When you want to stop printing, delete the already
received data.
Press the
1
(DATA CLEAR) in LOCAL.
Press the
2
• The received data is erased then it returns to the
Local.
Behavior after printing has been
completed
Drying Feed
If set "DRYING FEED" in the MACHINE SETUP to other
than "OFF," after completing the print, it will start the feed
operation in order for the print surface to be dried by the
optional heater unit 1800 or external heater.
• Perform the feeding operation until the back edge
of printing passes the heater.
• When you press the [END] key, the operation is
terminated.
• When the machine has been received next data
continuously, it will operate after the last data is
received.
Screen display during drying feeding
Drying
Please wait
POST1 POST2
30° /40°30° /35°40° /50°
(LOCAL) during printing.
key, and then press the
key.
FAN
2-19
2
2
2
5
6