Setting Ink - MIMAKI TS300P-1800 Operation Manual

Setting Ink

Take out the 2L ink pack.
1
• Take out the 2L ink pack and the IC chip from a
small cardboard box.
IC chip
Mount the IC chip.
2
• Be careful of the IC chip direction. If it is set in the
wrong direction, ink is not supplied properly.
Insert the chip facing the metal
side to the left.
Do not touch the metal part
while inserting. (The IC chip
may be damaged by static
electricity.)
Put the 2L ink pack into the
3
2L eco case.
(1) Open the 2L eco case as shown on the right.
(1) While pressing
the finger grip,
2L ink pack
IC chip
(2) open to right
and left.
Chapter 1 Before Use
(2) Tear off the seal on the connector of the 2L
ink pack.
• Be careful of the IC chip direction. If it is set in the
wrong direction, ink is not supplied properly.
OK
(3) Put the 2L ink pack facing the connector
down, and close the 2L eco case.
groove
part
• When putting the 2L ink pack, shape the pack
referring to the label in the 2L eco case. If
unshaped, you may not use up the ink.
• Before closing the 2L eco case, make sure the
connector of the ink pack is placed on the groove
part of the 2L eco case. If it is not placed on the
groove, it may not supply ink.
Seal remaining
1
No Good
2
2
2
5
6
1-11