Powering On The Server For The First Time - Oracle sparc M5-32 Installation Manual

Powering On the Server for the First
Time
Step Description
1 Review the preinstalled software
environment.
2 Check the power cords to ensure that they
have been installed and secured correctly.
3 Understand the dual-redundant SPs and
make serial connections to the SER MGT
ports on the two SPs.
4 Switch on the facility circuit breakers to
supply power to the server, which will go
into standby power mode.
5 Log in to the Active SP.
6 Assign the required network addresses for
the Oracle ILOM software, and set the
server altitude.
7 Use Oracle ILOM commands to power on
the server and configure the preinstalled
Oracle Solaris OS.
8 Explore and test the software environment.
Related Information
"Installation Task Overview" on page 1
■
"Installing the Server" on page 73
■
"Connecting the Front SP Cables" on page 97
■
"Connecting the Rear Power Cords and Data Cables" on page 119
■
Link
"Installed Software" on page 142
"Inspect the Power Cords" on page 142
"Dual-Redundant SPs" on page 143
"Connect Terminals or Emulators to the SP SER MGT Ports"
on page 144
"Switch On the Facility Circuit Breakers" on page 145
"Log In to the Active SP" on page 148
"Set Oracle ILOM Network Addresses" on page 150
"Set the Altitude of the Server" on page 153
"Power On the Server" on page 154
"Oracle Solaris OS Configuration Parameters" on page 156
"Additional Software Configuration and Testing" on
page 157
141