Oracle sparc M5-32 Installation Manual page 142

2. If you have routed the power cords down the right cable channel and through a
floor cutout, skip to
Otherwise, continue to the next step.
3. Confirm that the power cords have been routed up through the right-most
opening at the top rear of the server.
4. Secure the power cords to a cable tray or similar device above the server.
Refer to the cable tray documentation for instructions. Skip to
5. Confirm that the power cords are routed through the right cable channel and
down through the bottom of the server.
6. Confirm that the right cable bracket is installed in the right cable channel.
See
7. Using tie-wraps, secure the power cords to the right cable bracket and right
channel cable stand-offs.
Ensure that the power cords are routed to the left of the door latch bracket.
Note – When routing the power cords down the right cable channel, ensure that you
provide enough space for the rear door latch to close without touching a power cord.
132 SPARC M5-32 and SPARC M6-32 Servers Installation Guide • December 2014
Step
"Prepare the Cable Routing Brackets" on page 123
5.
Step 9.
for instructions.